环形通道内液态铅铋合金流动换热特性实验研究

通过对环形通道内液态铅铋合金的流动换热特性进行实验研究，得到了气泡泵注气对液态金属流动的影响，并拟合出环形通道内液态铅铋合金的摩擦系数关系式和换热特性关系式。结果表明：采用气泡泵注气能有效提升铅铋合金的质量流速；相同Reynolds数下环形通道内液态铅铋合金的摩擦系数大于由布拉休斯公式计算得到的摩擦系数；液态铅铋合金对流换热过程中，导热项占主导地位，并且Nusselt数随Peclet数的增大而增大。     

Simplification and applicability studies of a hydrogen-air detailed reaction mechanism

The research of hydrogen fuel internal combustion engine (HICE) had great significance facing the challenges of energy and environmental problems. Based on the detailed hydrogen-air reaction mechanism, the pre-mix model of CHEMKIN-Pro software was selected to simplify the detailed mechanism GRI-3.0. The most important elements and reactions was chose to construct framework mechanism firstly based on the sensitivity coefficient for H₂O and NO formation, and additional elements and reactions were added to framework mechanism for complementing the oxidation path of N2 and H₂. A simplified mechanism including 24-step elementary reaction was obtained and the laminar burning velocity calculated by this simplified mechanism matches well with the detailed mechanism in a wide range. This simplified mechanism was also applied in a CFD model which predicted the cylinder instantaneous pressure and NOx emission accurately within a large range of fuel air equivalent ratio. Showing that this mechanism has good applicability.     

An experimental study on the spray characteristics of pressure nozzle in a fluid bed granulation

The particles with a narrow size distribution are proper products in a fluid bed granulation and coating. As well, the process efficiency is one of the most important parameters, and the wall deposition of sprayed liquid reduces it. The modality of spray volume distribution is a key parameter in the definition of particle size distribution and process efficiency. This work is done in two steps: In the first step, an experimental study on spray characteristics including spray flux distribution, spray cone angle, and discharge coefficient is conducted. Based on the experimental data, the curves of liquid volume flux versus nozzle pressure and height are obtained. The results indicate that the flux distribution changes significantly with even small pressure and height changes. In the second step, the granulation process is carried out in a semi-industrial conical fluid bed, and the particles size distribution curves and the deposited mass on the bed wall are obtained. The results show that the precise determination of the spray flux distribution is an appropriate way to predict the well-advised nozzle pressure/height in order to achieve the narrow particle size distribution and high efficiency of the process.     

Effect of nonlinear thermal radiation on 3D magneto slip flow of Eyring-Powell nanofluid flow over a slendering sheet with binary chemical reaction and Arrhenius activation energy

An analysis is performed to study the combined effects of nonlinear thermal radiation, Arrhenius activation energy, chemical reaction and heat generation/absorption on the steady three-dimensional magnetohydrodynamic flow of Eyring-Powell nanofluid flow over a slendering stretchable sheet with velocity, thermal and solutal slips. The prevailing partial differential equations are transmuted into coupled non-linear ordinary differential equations via with the suitable similarity transformations. The resultant non-linear coupled differential equations are solved numerically by using the R-K 4^th order method along with shooting scheme. The results are calculated to measure the influence of sundry parameters on velocity, temperature, concentration, shear stress, temperature gradient and concentration gradient are presented graphically and in tabular form. It is noticed that the temperature is more impactable for higher values of radiative heat transport. The local Sherwood number decays exponentially for all the values of the chemical reaction parameter. We compared the present results for the limiting cases with previously published results, which has shown reliability and efficiency.     

自然循环工况下离心泵阻力特性的实验研究与数值模拟

停转后泵的阻力特性对自然循环流量影响明显。为研究低流量自然循环工况下离心泵的阻力特性，设计了实验台架，对离心泵的正向压降、反向压降和损失系数进行了测量，实验雷诺数为2.0×10⁴～1.5×10⁵。实验表明：相同雷诺数下，反向压降明显高于正向压降；雷诺数大于8×10⁴时，损失系数基本保持不变，而低雷诺数下损失系数随雷诺数的降低有增大的趋势；基于实验得到了损失系数的经验关系式。采用CFD方法对离心泵的内部流场进行了模拟，计算表明：CFD方法能较好地预测损失系数，RNG k-ε模型与实验值的相对误差不超过10%；离心泵的压力损失主要集中在叶轮、导叶等结构的交界区域；正向与反向流动的流场分布存在显著区别；低雷诺数下局部流动更加不稳定。     

高分辨连续光源原子吸收光谱法测定铀铌铅多金属矿中痕量银

铀铌铅多金属矿组成成分复杂,准确有效的测定其中的痕量银,有利于银的回收利用。采用HCl-HNO₃-HF-HClO₄处理铀铌铅多金属矿样品,以HCl(1+4)-2g/L酒石酸为测定介质,以λ_Ag=328.068nm为分析谱线,建立了高分辨连续光源原子吸收光谱法(HR-CS-AAS)测定铀铌铅多金属矿样品中痕量银的新方法。对仪器参数进行了优化,确定采用迭代基线校正(IBC)背景校正方式,CCD检测器有效像素点选择5个;由银的平均吸收光谱图和吸光度-波长-时间三维吸收光谱图可知,银的CCD检测器分辨率为0.0020nm/pixel,λ_Ag=328.068nm在327.86~328.27nm范围内没有受到溶液中其他共存元素的谱线干扰。在优化的实验条件下,银的吸光度与其质量浓度在0.40~1.60μg/mL范围内运用二次方程最小二乘法拟合校准曲线,相关系数为0.9999,特征浓度为0.0148μg/mL,方法检出限为0.0013μg/mL。将HR-CS-AAS测定样品中银的参数与空心阴极灯原子吸收光谱法(HCL-AAS)相比,其检出限更低,特征浓度更低,标准溶液系列的吸光度更高。按照实验方法对铀铌铅多金属矿样品中的银进行测定,结果与电感耦合等离子体质谱法基本一致,相对标准偏差(RSD,n=9)为0.63%~3.3%。按实验方法在铀铌铅多金属矿样品中加入银标准溶液进行加标回收试验,回收率为97%~104%,满足国家地质矿产行业标准DZ/T 0130—2006的要求。     

Clearance of FGF‐23 during continuous renal replacement therapy

FGF‐23 is a 32 kDa protein that is a key regulator of phosphorus and vitamin D metabolism. Emerging evidence also demonstrates that FGF‐23 increases within 24 hours of acute kidney injury (AKI) and may be associated with adverse clinical outcomes. We conducted this study to evaluate FGF23 clearance during continuous veno‐venous hemofiltration (CVVH) in critically ill patients with AKI. We demonstrate that plasma clearance of FGF‐23 during CVVH is ～11 mL/min and the mean sieving coefficient is 0.27 ± 0.1. Future studies will need to clarify FGF‐23's role in adverse outcomes among AKI patients, and whether therapies aimed at reducing FGF‐23 levels may be beneficial.     

Measurements and modeling of absorptive partitioning of volatile organic compounds to painted surfaces

Partitioning to surfaces is an important sink for volatile organic compounds (VOCs) indoors, but the mechanisms are not well understood or quantified. Here, a mass spectrometer was coupled to a portable surface reactor and a flow tube to measure partitioning of VOCs into paint films coated onto glass or wallboard, and their subsequent diffusion. A model was developed to extract values of the effective absorbing organic mass concentration of the film, C_w, which is a measure of absorption capacity, and VOC diffusion coefficients, D_f, from VOC time profiles measured during film passivation and depassivation. Values of C_w agreed well with the value estimated from the paint film mass and flow tube air volume, and D_f values (also measured using attenuated total reflectance-Fourier transform infrared spectroscopy) correlated well with VOC vapor saturation concentrations, C*, estimated using a group contribution method. The value of these relationships for estimating key parameters that control VOC partitioning into paint and the fate of VOCs indoors was demonstrated using a house model, which indicated that >50% of VOCs with C* ≤10⁸ μg/m³ (C* of octane, hexanone, and propanol) that contacted a paint film of typical thickness fully permeated the film regardless of emission duration.     

Synthesis and spectroscopic studies of some new azobenzenesulfonamide

Abstract

Diazotized sulfadiazine derivative (1) was coupled with some nitrogen heterocyclic namely (thiazolone derivatives 2a–c, thiazole derivatives 4a–c and barbituric acid derivatives 6a,b) to give the corresponding azo compounds 3a–c, 5a–c and 7a,b in good yields. The newly synthesized azo benzene sulfonamide dyes were recorded their UV visible spectra in the region 200–600?nm in four different solvents and discussed the effect of solvents, substituent and effect of acid and base on the absorption values of these dyes.     

酵母菌的致孔作用对PVA/CMC水凝胶性能的影响

利用酵母菌发泡制备了聚乙烯醇/羧甲基纤维素多孔水凝胶(D-PC)，采用FTIR对其化学结构进行了表征和Zeta电位分析共同证明了酵母菌和材料之间的相互作用；利用SEM和BET分别对其三维网络结构进行了观察以及比表面积、孔径进行了测定；研究了D-PC在不同条件下对亚甲基蓝(MB)的去除，通过纤维素降解酶实验测试了D-PC的降解性。研究结果表明：酵母菌通过静电作用包覆在D-PC内；随着酵母菌量的增加，D-PC的比表面积增大、平均孔径减小；D-PC对MB的去除机制以化学吸附为主，且吸附动力学符合伪二级动力学方程；去除效率随着酵母菌的增加而增大，随着pH、温度的增加先增大后减小；一定条件下D-PC能降解水凝胶中的聚乙烯醇。